FOIL -INSULATION

Our Products come in following dimensions.
 Foil Single Side/Double Side.
 Available in thicknesses from 1mm to 50mm
Foil Insulation Guide lines
 Lay Eco Foil over and across the purlin, making sure aluminum foil facing the roof sheets
 Attach one end of the foil to the top most purlin at the upper end of the roof by means of reverts or self-tapping screws
 Use air gap tape lay over the Foil along the purlin to get a fine fixing effect and also to create the air gap
 Gently pull tight from the lower end of the foil and avoid sagging and attach the foil to the next purlin at the lower end
 This method should be continued till the foil reaches the last purlin at the lower end (air gap tape should fix along all the purlin)
 Make sure the tension of foil along the length is almost equal to ensure a better jointing effect, which gives the fine finish and appearance to the insulation without sagging and opening between seams
 After installing the first length of Foil, roofing sheets can be installed over the insulation as per roofing sheets manufacturer’s instructions
 Lay the second length of Foil sheet parallel to the first length making sure seam is joined by the butt joint or overlap joint (about 50mm)
 Butt joint is recommended for thickness 8mm and above and overlap jointing is recommended for thickness below 8mm
 Use company recommended Aluminum self-adhesive tape for butt joint and double side adhesive tape for lap joint
 Attach the second length of Foil sheet also to purlin by means of air gap tape and reverts or self-tapping screws.